 Dynojet's PowerCommander 6 for the Yamaha WR250R/X is highly recommend any time you want to improve the ride-ability and improve performance of your stock WR250R/X, or whenever you install an aftermarket exhaust and/or air filter. This is a must-have mod for these bikes and will make them run much better. Benefits on a Stock Yamaha WR250R/X: If you're keeping your engine stock and leaving the OEM exhaust system, a PowerCommander 6 is a great choice. The WR250R/X runs lean with the factory fuel map and really falls on its face in the low to mid range when you hammer the throttle. Dynojet has a "stock improved" map for use with the stock exhaust system, which will make the bike run better, helping eliminate that dead spot early in the powerband and give it better overall ride-ability throughout the powerband. Benefits on a Stage 1 Yamaha WR250R/X: If you've decided to add an aftermarket exhaust and/or intake system (Stage 1 mods) to your WR250R/X, a PowerCommander 6 is HIGHLY RECOMMENDED if you want to take full advantage of those performance parts. Aftermarket intakes/air filters give your engine more air, and exhaust systems allow it to breath better. Without an EFI controller, the bike will run lean and you may experience pinging or backfiring, and the bike may run hot. Additionally, without the proper fueling that an EFI controller provides, you will see little to no performance gains from your new exhaust system and, in fact, your bike may run poorly. With the PowerCommander 6, you can use their maps for an aftermarket exhaust system, which will then make the bike run properly and help take advantage of the more open exhaust system. The New PowerCommander 6: Tried, true and tested the Power Commander continues to evolve with the Power Commander 6. Developed to simplify the user experience, PC6 makes choosing and tuning a map easier for the end user. All the same benefits you have relied on for over 20 years remain to keep you at the front of the pack. The Power Commander 6 fuel injection tuning device allows you to optimize your fuel and timing curve (where applicable) giving you the confidence to roam freely. With fine tune adjust-ability and multiple inputs, the Power Commander 6 will keep your vehicle running at its full potential letting you concentrate on the journey ahead. Featuring a plug-and-play setup, Power Commander 6 can be installed discreetly underneath your seat, cowl, dash or other location ensuring your ride looks as good as it runs. Removing the device reverts your vehicle completely back to stock. With the ability to store and switch between two maps on-the-fly (via the map switch accessory) and connect to various Power Commander accessories such as the Autotune, Quickshifter or POD-300, the Power Commander 6 gives you features and functions that provide you with the ultimate ride. Fitment: 2008 - 2020 Yamaha WR250R and WR250X Installation and Map Info: This PowerCommander 6 ships with a "stock improved" map if you want to make your bike run better with the stock exhaust. Dynojet lists additional maps you can download free of charge on their WR250R/X Product Page if you've added an aftermarket exhaust and/or air filter. There you will find installation instructions, additional maps, and so on. Standard Features: ** IN STOCK - Usually leaves our warehouse in 1-3 business days. |
WARNING! - Motor sports can be extremely dangerous, injury or death can occur. No warranty is made or implied regarding any product sold by Devo Tech, Inc. / SoloRacer.com to protect users from injury or death. The user assumes all risks. Please read the rest of our Legal Disclaimer before ordering. Our on-line store is up and running 24 hours a day, 7 days a week. We use Yahoo! Secure Servers for all transactions so you can shop with complete confidence. If you are uncomfortable ordering online, call or email us for more ordering options. ©Copyright 2002-2024 by Devo Tech, Inc. |